SKU: 46991370283
supro effects pedals

supro effects pedals Supro Tremolo

Sale price$26.67 Regular price$29.63
Save 10%

Pay in installments of $7.41 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 21 - Aug 26

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

supro effects pedals Supro TremoloSupro Tremolo 1310 The Supro Tremolo is an analog stompbox designed to recreate two of the most desirable vacuum tube based modulation effects found in American amplifiers of the 1960's. The Supro Tremolo pedal's AMPLITUDE HARMONIC switch allows the musician to choose between these distinctly different, vintage effects. AMPLITUDE mode provides the traditional swampy, tremolo sounds generated by bias modulating the power tubes in the original Supro

Supro Tremolo 1310


The Supro Tremolo is an analog stompbox designed to recreate two of the most desirable vacuum tube based modulation effects found in American amplifiers of the 1960's. The Supro Tremolo pedal's AMPLITUDE / HARMONIC switch allows the musician to choose between these distinctly different, vintage effects. AMPLITUDE mode provides the traditional swampy, tremolo sounds generated by bias modulating the power tubes in the original Supro amps. HARMONIC mode provides the psychedelic tones of Leo Fender's brownface and blonde amps from the early 60's. We've implemented Leo's unique "harmonic tremolo" effect within the output stage of the pedal to create an "amp-like" modulation experience.


The Supro Tremolo pedal features pre-amp and power amp sections, with an actual output transformer deployed to recreate the magnetic saturation and coloration of the original vacuum tube based effects found in these historic amps. Along with the standard modulation controls for speed and depth, the Supro Tremolo also features a gain circuit that allows the musician to overdrive the output stage, right where the modulation effects are created. The GAIN control sets the amount of "preamp" gain in the pedal. As you turn the gain up, the "power amp" circuit will gradually be pushed into overdrive. This control gives you a wide range of sounds from clean to grind, with magnetic saturation occurring as the power section is pushed into overdrive. As you crank up the gain, the overall output level of the Supro Tremolo is automatically compensated in order to maintain consistent signal level. This allows the musician to use the GAIN control to alter the texture of the modulation effects without an overwhelming increase in audio output level.



 

Features:

    • Switchable AMPLITUDE or HARMONIC modes
    • Emulates a Class-A tube amp circuit from end-to-end
    • Gain control with auto level compensation
    • Expression pedal control for SPEED


SPEED and DEPTH controls determine the rate and amount of modulation present in the effect. An industry-standard TRS expression pedal can be used to control the speed of the Supro tremolo. When an expression pedal is in use, the on-board SPEED knob is used to set the maximum value. The rate of modulation is indicated by the pulsing LED status indicator. All Supro pedals are assembled in Port Jefferson, NY, USA, featuring custom-tooled, anodized, brushed-aluminum enclosures, 9V battery or DC powered operation, rear-mounted metal jacks, easy-access side-mounted battery drawer and studio-friendly, noiseless (click-free) true-bypass switching.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 46991370283

Discover Niche Categories That Outsell supro effects pedals

Top-Converting Item to Boost Your Average Order

4.7 ★★★★★
Based on 16 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
B
Verified Purchase
Brian M.
Birmingham, US
★★★★★ 5
Sounds great.
Just received my Onkyo TX-NR 7100, watched a few YouTube videos before it arrived, so set up was easy. Ran accuEQ, I am getting new front speakers so I’ll wait to run Dirac. After accuEQ, I still had to make a few adjustments, to the speaker levels and especially the sub. It set my subwoofer way too low. As of right now having no problems with Bluetooth. I’ve only listened to music so far, can’t wait to watch a movie. For now I have a 5.1.2. System, getting new fronts, the Klipsch r51-m’s will go to the rear surround and Klipsch r41-m’s will be my height speakers in a 5.1.4 system. So far loving this avr. Update 2: Just calibrated with Dirac for the 6th time. They tell you if you sit in a recliner, reclined measure with it reclined. Well I measured with the chair in its upright position. It makes a huge difference I hear the surrounds much better. Btw I listen to all channel stereo, I know audiophiles say it sucks, however I listened to 2 channel stereo for 20 years, when there was nothing else. I didn’t buy a 9 channel avr to listen to 2 channel stereo. Like Randy the cheap audio man says “ audiophiles aren’t always right. If it sounds good to you, that’s all that matters.” So try calibrating in the upright position, or if you sit on a stationary chair or couch, try positioning the mic slightly forward of your listening position. It makes a huge difference. Hope this helps, enjoy. Update: Ok bought Klipsch rp-600m speakers for the front with 52c center. 51m surrounds, 41m rear heights. Polk owm3 front heights. Why Polk? Lighter easy to hang and as height speakers they are only there for atmos. Ran Dirac live, the application does what it would take several hours to make it sound like it does, if I even could get it to sound so good. Apple TV 4K with my Hisense U8K. The google tv interface is ok, but Apple TV is faster and easier. The Onkyo 7100 is a gem, runs pretty warm but I have it out in the open. If you are going to put in a cabinet I suggest a fan. Very happy with the whole system.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 11, 2025
A
Verified Purchase
Amazon Customer
Fort Morgan, US
★★★★★ 5
Great for UTV rear light install!
Size: 16AWG -10FT 2Pin DT
I had a set of 3” Nilight pod lights with wiring harness to install as rear lights on my Ranger 570 SP. The Nilight harness with relay was great! But it was too short to keep the relay and fuse in the front compartment on the pulse panel. These were the perfect solution! The extensions are plugged in under the tunnel to each of the individual light leads from the Nilight harness. And there was just enough length to run behind the seat back, up the driver side roll bar, and to each light. (Had about 1’ too much for passenger side light, so should be fine for full-size Ranger too.) Now have a weatherproof, factory quality installation with no splices or solder joints. The only mods I had to make for the entire install (not related to these extension cables) were: 1) Cutting the ring lugs off and adding waterproof heat shrink butt splices to Polaris pulse plug, and 2) Buying a factory-style Carling L1 illuminated switch to replace the round switch provided. (This is a direct plug and play too since the Nilight switch wiring has 1/4” faston connectors.)
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 27, 2024
M
Verified Purchase
Marshall Quinn
Fort Morgan, US
★★★★★ 5
Exactly what I needed
Size: 16AWG -10FT 2Pin DT
This was perfect for me. I had two lights bars in my rear bumper and needed to extend the harness to my fuse block. Great value
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 19, 2026
C
Verified Purchase
Charles G
Pawtucket, US
★★★★★ 5
10 foot long
Size: 16AWG -10FT 2Pin DT
Worked great. Plugged in with no problem.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 12, 2026
Y
Verified Purchase
YETI FRED
Los Angeles, US
★★★★★ 5
Affordable
Size: 16AWG -10FT 2Pin DT
Used them to install Morimoto 2 Banger pods on my vehicle. Casing for the wires is thick enough that will stand the weather and abrasion. I spliced them to make just one run, added braided sleeving (for looks and additional protection). The wire quality and thickness made the connection with waterproof connectors strong and durable. Saved me around 20 dollars as compared to brand name wires.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 24, 2024

recommand products